Specna Arms Gen.2 EDGE Series M4 Airsoft AEG Rifle w/ HAL2 ETU
All the capabilities of the HAL² ™ and the Specna Link™ app
- Trigger sensitivity adjustment
- Precocking for faster trigger press response
- Selectable shooting modes: SINGLE, BINARY, SERIAL or AUTO and assign it to the selected selector position
- Adjustment of batch length
- Rate of fire setting
- LiPo/LiIon battery over-discharge protection
- Magazine mode
- Continuously displayed battery charge status
- Save settings for different game modes
- Advanced telemetry data, which can be collected in one place and performance can be monitored with it
- Ability to track the status of the replica in real time
- Aluminum alloy upper and lower receiver
- 380 fps (1.01 - 1.33 Joules)
- 380 FPS spring pre-installed from factory, optional 310 FPS (M90) spring included to reduce muzzle velocity
- Aether lightweight reinforced ver. 2 gearbox shell with high strength metal internals and aluminum sealed nozzle
- Pre-installed HAL MOSFET system and Dark Matter Brushless motor for stable performance even at high speeds with lower heat generation
- ESA (Easy Spring Access) system allows tool-free spring swaps in a matter of minutes or even seconds
- Includes a 125rd Mid cap magazine, compatible with MOST other m4 AEG magazines
- MAGNUS Rotary type TDC hop up with Specna Arms's Helium flat hop bucking and 6.03mm tight bore barrel
- Flat competition-style trigger with slip resistant grooves
- Uninterrupted top Picatinny mount for optics and includes flip-up front and rear iron sights
- Adjustable 6-position light OPS stock with battery storage
- 2x ambidextrous QD sling points on the handguard and one on the stock
- Inner Barrel: 6.03mm x 210mm
- Wired to the rear buffer tube with a Deans connection with a Small Tamiya adapter as well
- Product shipped with an orange tip. Due to supplier regulations
- Optic Not Included
NOTE: Trigger system may need to be activated, please check MOSFET manual.
HAL MOSFET Quick Start Guide:
Plug in the battery
Wait till a beep can be heard
Hold the trigger for 3 - 5 seconds until 2x beeps can be heard
Once complete the MOSFET has been successfully programmed
