AIRTAC - CZ P-09 to M4 HPA Adapter
The Airtac HPA/M4 adapters are now here! Show them speedy bois how its done by slamming these into your pistol of choice! *Assembly required for all adapters*
- Compatible with ASG CZ P-09 magazines
- CNC Mag Release and Feed Tube
- Includes single stack adapter and O ring
- BB retention mechanism to reduce BB loss during magazine changes
- US HPA FITTING as standard
- M4 magazine NOT included
- US HPA FITTING as standard
-
Assembly required with all adapters! (Pre-fitted magazine/adapters are available)
- Required parts for assembly are all found on an existing magazine of the same type
Punch out the grip panel pin with your finger over the lanyard loop. When the pin is out, carefully remove the lanyard loop (there's a spring), and place our lanyard delete into the hole. Re insert the pin. JOB DONE!
HPA ADAPTER
Installation is simple. Remove your gas base by knocking out the two large pins at the bottom of the mag (they can be knocked out from either side). Knock out the small pin in the BB channel of the magazine. Remove the spring and follower, and insert our single stack adapter into the magazine.
Place the O ring from the gas base plate of the CZ P-09 mag onto our adapter, and insert into magazine. Using the clamp to apply compression, line up the pin holes and fully re-insert one pin at a time. You’re then good to go!
